Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateGate Company in Tualatin, OR
Gate installation in Tualatin usually means replacing a perimeter, pool or community gate that’s reached the end of its life, and the work here has a different rhythm than in newer suburbs. Most of the housing went up between the 1970s and the 1990s, and the builders used wood and chain-link gates that have now seen three or four decades of Willamette Valley rain. When we quote a new gate in Tualatin, the ground matters as much as the gate: valley silt holds water, posts heave, and a gate that looks straight in July can bind by February. Call (866) 942-6384 for a free on-site estimate.
Why Tualatin Homes Are Different
Tualatin sits in a wet pocket of the valley, close to the Tualatin River floodplain, and that shapes nearly every gate job we look at. Winters here run damp for months rather than freezing hard, so the soil under a gate post stays saturated long after the last rain. Wood posts rot from the ground up before the gate panel itself shows any trouble. Chain-link frames rust at the bottom rail first. Hinges and latches wear because the post beside them has moved, not because the hardware failed.
The housing mix explains the rest. Tualatin is built mostly from late-20th-century tract homes plus a dense layer of 1980s to 2000s apartment and condo communities with shared perimeter fencing and community gates. That means lots of builder-grade wood and chain-link, and very little custom ironwork. In the older subdivisions off Boones Ferry Road and near the river, we regularly find a gate that “mysteriously” stopped latching because the post shifted half an inch over winter, not because the hinge broke. Ice storms and wind events finish the job on lighter residential panels, bending frames that were already loose.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Our Main Tualatin Services
Most calls we get from Tualatin fall into two groups: a gate that’s stopped working, and a gate system that needs to be replaced outright. Here’s what each one involves locally.
Gate Repair in Tualatin
Repair work in Tualatin is dominated by aging residential perimeter and pool gates. On the 1970s and 1980s subdivisions, the recurring failures are rotted wood posts, sagging hinges and latches that no longer line up because the ground moved underneath. We diagnose from the footing up rather than adjusting a hinge that was never the problem. Rusted chain-link frames and bent lighter-duty panels after winter storms are the other steady call. If your gate is sticking, dragging or refusing to close, gate repair starts with finding whether the post, the hardware or the panel failed first.
Electric Gate Repair in Tualatin
Automated gate problems in Tualatin often trace back to the same wet-soil issues, just with an operator attached. A post that heaves throws the gate out of alignment, the operator keeps pushing, and the control board or motor takes the strain. We work on operators from Linear, Viking, DoorKing and most other major brands, and we check mechanical alignment before we touch the electronics. Not every non-responsive gate needs a new board. electric gate repair covers the full chain from motor and control board to the safety edges and wiring that keep an automated gate safe to use.
Gate Installation in Tualatin
New gate installation in Tualatin is mostly a replacement story. In the older subdivisions and the multifamily communities around Meridian Park and Tualatin Heights, the original builder-grade wood and chain-link gates are now 30 to 50 years old, and the honest fix is a new gate on properly set posts rather than another round of hinge adjustments. Add the wet valley soil and the occasional ice storm, and you get a steady base of residential perimeter, pool and community gates that have simply outlived their hardware. We handle gate installation as our core work, measured and quoted on site before anything is ordered.
Automatic Gate Installation
Signs you need it
You need automatic gate installation when an existing manual gate has been pushed open and dragged shut for years, or when an older operator has failed and its replacement no longer matches the gate it was paired with.
What it costs in Tualatin
Automatic gate installation in Tualatin typically runs $3,500 to $8,500 depending on gate size, material and operator, and the written estimate sets the final price.
How we do it
We measure the opening and check the ground where the posts will sit, set posts to proper footing depth, hang the gate, then mount and program the operator with its safety edges and test the full cycle.
Driveway Gate Installation
Signs you need it
A new driveway gate makes sense when the existing one is rotted at the base, has been bent by a storm, or was sized for a narrower drive than the vehicles now using it.
What it costs in Tualatin
Driveway gate installation in Tualatin typically falls between $2,500 and $7,000, with the material and the width of the opening doing most of the work on that range.
How we do it
We set out the opening, dig and set the posts to proper footing depth so valley soil can’t heave them, hang the leaf or leaves to swing clear of the ground, and fit the latch and stops.
What Gate Installation Costs in Tualatin
| Item | Typical range in Tualatin |
|---|---|
| Automatic gate installation (gate plus operator) | $3,500 – $8,500 |
| Driveway gate installation | $2,500 – $7,000 |
| Electric gate installation (operator and controls) | $3,000 – $7,500 |
Do you handle the power run and the safety edges on a new automatic gate?
Yes. We handle the operator wiring, controls and safety edges as part of automatic gate installation, and we test the full cycle with the edges active before we call the job finished.
Can a new gate in Tualatin be built to survive the wet soil?
Yes, when the posts are set to proper footing depth rather than the shallow set the original builder used. That single step prevents most of the leaning and binding we see in older Tualatin gates.
Brands We Service in Tualatin
We work on nearly every major gate brand, including Linear, Viking, Ghost Controls and DoorKing, on both residential driveways and commercial access systems. We don’t claim to stock parts for every brand, so turnaround depends on what the system needs. See our brands for the full list.
See the difference
Before
After
Before
After
Before
AfterPricing for Gate Company in Tualatin, OR
| Service | Typical range in Tualatin |
|---|---|
| Automatic gate installation | $3,500 – $8,500 |
| Driveway gate installation | $2,500 – $7,000 |
| Electric gate installation | $3,000 – $7,500 |
| Sliding gate installation | $3,000 – $9,000 |
| Gate repair (hardware, hinge or latch) | $150 – $450 |
| Gate post replacement | $250 – $800 |
| Electric gate repair (operator or control board) | $200 – $700 |
| Safety edge or sensor replacement | $200 – $550 |
In Tualatin, the price usually climbs with the condition of the ground: a post that has to be pulled out of saturated valley silt and reset to proper footing depth costs more than a hinge swap. Every job is quoted and agreed before any work starts, so the number you approve is the number on the invoice.
Neighborhoods We Serve in Tualatin
We cover gate repair and installation across Tualatin, including the older subdivisions off Boones Ferry Road, the multifamily and HOA communities around Meridian Park, Tualatin Heights, and the properties closer to the river floodplain in 97062. Reach us and we’ll book a site visit for your address.
- Meridian Park
- Tualatin Heights
- Boones Ferry Road corridor
- River floodplain properties
Service Area – Cities Near Tualatin
We also take gate work in the towns around Tualatin. If you’re just outside the city line, we can usually cover you from the same crew schedule. We regularly work in Tigard, OR, West Linn, OR, Gladstone, OR and Oregon City, OR. Call with your address and we’ll confirm coverage and book a free on-site estimate.
Serving Tualatin, OR – Our Local Coverage Area
We serve Tualatin and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs About Gate Company in Tualatin
We answer 24/7, and dispatch runs 7am to 7pm, Sunday through Friday. Calls outside those hours are booked into the next opening. A call outside dispatch hours is booked into the next opening, Sunday through Friday, 7am to 7pm.
It depends on the gate and the property. HOA communities around Meridian Park and Tualatin Heights often require architectural approval before a gate style changes, and the city may require a permit for structural posts or electrical work on an automatic gate. Ask your HOA and the city building department before ordering.
Yes. A large share of Tualatin gate work is shared perimeter and community gates in multifamily complexes. We handle both residential driveways and commercial access systems, and we can quote a replacement for a community gate on site.
Call (866) 942-6384 for a free estimate on your gate in Tualatin. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
What happens when you call
- 1A real person answersNo phone trees. Talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3A background-checked tech heads outLicensed & insured, typically the same day.
- 4You approve before work beginsNothing starts until you say go.
What Tualatin Customers Say
"Repair is holding. He was quite a bit later than the window I was given, and nobody called me about it, I had to call them. The work itself was done well once he got here."
- Rohan Shah"We had a hydraulic arm leaking fluid onto the driveway. Replaced, cleaned up the stain as best he could, and it's been dry for months."
- Marcy Walsh"Gate works properly now and the price was fair. The one thing is that it took two visits, because the operator model we have is old and the part had to be ordered. They didn't charge for the second trip."
- Alma Mendoza